Fuel Injector troubleshooting

May 10, 2019 Leave a message

Fuel Injector troubleshooting

 

1. Nozzle blocked

The needle can be used for dredging, and it should be carefully cleaned after dredging. The large plane of the needle valve body is in poor contact with the plane of the injector body, or the cylindrical surface of the needle valve is worn a lot. If the large plane of the needle valve body is in poor contact with the plane of the injector body, chrome oxide may be applied to the flat plate for "8" shape grinding; if the cylindrical surface of the needle valve is worn out, the needle valve coupler shall be replaced in pairs.


2. Poor sealing

Poor sealing of the needle valve and the needle valve body, resulting in poor atomization or dripping of the injector.

This kind of failure can be applied to the sealing tape at the end of the needle valve with fine chrome oxide or toothpaste, but never put it on the cylindrical part, then insert the needle valve into the needle valve body and knock it until it closes. The chromium oxide or toothpaste must be washed away after grinding.

 

3. Have air

There is air in the oil circuit. Simply remove the air from the oil circuit.

 

4. Poor oil supply

The oil pump needs to be overhauled. If the oil pipe joint leaks, try to connect it so that it does not leak.

 

5. Insufficient elasticity

The spring force of the piston spring is insufficient or the spring is broken. The spring should be replaced.

 

6. Piston wear

Piston wear affects fuel supply. The piston needs to be replaced.